Slave Cylinder?????

Started by Drft-s12 · Jan 18, 2007 · 7postsInvision 2005–09

Drft-s12Jan 18, 2007, 3:35 am · #1

What other tranny can i get a slave cylinder that will work for the fj? Cause the fork going into the tranny bent and the slave wasnt fully aligned with the fork so pressing down on the clutch was really really really stiff. And today the slave went out on me so now pressing on the clutch is like butter and it will not go in gear. sad.gif

Drft-s12Jan 18, 2007, 11:09 pm · #2

Well took the slave off and its ok but the fork going into the tranny is broken so do i need a new tranny or can that be fixed?

Alex FrostJan 21, 2007, 10:19 pm · #3

no you don't need a new tranny, but you are going to have to remove the tranny to replace the fork. check your vin tag in the engine bay. You should have a FS5W71B tranny...if so grab a fork from any B tranny Nissan...I think C forks are the same, but I don't have both here to confirm this right now.

Drft-s12Jan 22, 2007, 5:37 am · #4

I have a Ka24e tranny would the fork off the ka work for the FJ tranny???

Alex FrostJan 24, 2007, 3:29 am · #5

The lieklyhood is yes. you have to take your tranny apart anyways (seperate it from the motor) so you may as well seperate it and see. May save you looking any further than the tranny you have laying around.

VEGIEJan 24, 2007, 10:17 am · #6

Drft-s12 @ Jan 22 2007, 05:37 AM
I have a Ka24e tranny would the fork off the ka work for the FJ tranny???

the fj transmission code is FS5W71B

so any "b" series forkshould fit. are you sure its broken? it may have just come unclipped from the pivot or bearing holder, either way, you'll need to take the gearbox out sad.gif

Drft-s12Jan 24, 2007, 7:46 pm · #7

Thanks that was what i was looking for so that means i can use one from a 240z. 260z, or something like that. Time to get the tranny off.