Dec 11, 2008, 3:14 am · #1
Just Bought an Engine stand Today, And Am Picking up My Ca18det Tommorow.
What bolts Do i use Or Will I need To Put this up on the Stand??
Engine Stand?
Dec 11, 2008, 3:15 am · #2
I only needed 4 for my RB20.
I think it also depends on your engine stand and what is available on your motor.
Dec 11, 2008, 3:15 am · #3
bellhousing bolts, or take them to the hardware store and get longer ones so they fit with the enginestand spacers
Dec 11, 2008, 3:34 am · #4
Ok I thought the Bellhousing ones wouldnt be long enough, just wantted to confirm, I will stop at home Depot on my way home.
Thanx Buds!
Dec 11, 2008, 12:13 pm · #5
You'll probably want bolts that are longer than the bellhousing ones.
Make sure you get metric ones with the same thread as the bellhousing ones (IMG:style_emoticons/default/wink.gif)
Dec 12, 2008, 6:19 am · #6
Damm Engine was Seperated from the Tranny And Never Got The Bolts.
Anybody KNow which size and thread I need?
Dec 12, 2008, 6:30 am · #7
most likly there the same as the Ca18ET bolts as the engine black is the same or similar.
This post has been edited by falkhen: Dec 12 2008, 06:31 AM
Dec 12, 2008, 7:56 am · #8
Dont even have the ca18et anymore either
Dec 12, 2008, 8:00 am · #9
why did you sell your motor?
how much did you get?
Dec 12, 2008, 8:53 pm · #10
I bought his car Without a Motor, tranny or Driveshaft
Dec 20, 2008, 12:31 am · #11
If you need longer bolts Nissan generally uses M10 X 1.25 for the bellhousing to engine...