Which TB Fits Best?

get about a foot of vaccuum line..(dont remember size, sorry...) and a t-connector for the vaccuum lines..a gasket for the TB, and some patience if yoyu have to swap over the springs form your VG throttle body to the KA24 TB...takes some time! (just cause its a pita)..if you dont get the springs (yes, there are two) right..you'll have a weak gas pedal, or weird ass accel...come on now,.. it wasnt that bad, took me about a whole 10 minutes to change out all the springs and stuff on the throttle bodies,.. probably would've taken even less if i would've done it before i had put the KA throttle body on the car already,..

as for the fans, i used ones off an '88 Maxima (w/ manual transmission).. i'm not sure if the tranny makes a difference in the fans, but the guy at the junkyard asked if i wanted ones off a auto or manual so i just went manual

anyways.. to mount these all you need to do is cut notches for the hoses, sensor and drain plug,.. (i did this using a metal cutting disk on my power drill) and then just use some zip-ties to hold it in place
http://www.club-s12.org/board/attachment.php?attachmentid=86&stc=1

i've also got the wiring setup so the fans are on one switch and it controls both the high and low speeds for both fans (down is low speed - green light and up is high speed - red light):
http://www.club-s12.org/board/attachment.php?attachmentid=85&stc=1

send me a PM if you want to know anymore about the wiring setup or anything (if you decide to go with the maxima fans) or you can IM me on AIM: Nissan200sx03

..frustration had set in a long time back...frustration almost always doubles the work needed! lol..its not too bad tho..i just had one mother of a time getting the springs switched over.

If you get the throttle body that has "Nissan" cast into it, it will fit perfectly without having to swap anything. The Hitachi throttle body's used on some KA24's need a little bit of modding to bolt up.

Here is a bad pic of mine on my car. You can see it has a "round" throttle return plate where the throttle cable attaches to it. http://www.streetneeds.com/uploads/cars/Ryan200SX03.jpg

..figures that i got the hitachi one huh?!

Best fans. the fans off the older nissan maxima it has twin fan it swaped then into my 300zx and my s12. frees up alot of space to
sure does free up some space! i used the fans out of a '88 Maxima

http://memimage.cardomain.net/member_images/9/web/237000-237999/237018_142_full.jpg

and here is a pic of the kind of space you get:
http://memimage.cardomain.net/member_images/9/web/237000-237999/237018_154_full.jpg

Hi, i recently located a few Nissan Stanzas from 90 all the way to 94, the TB from which car would bolt into my VG30E the best, with the least amount of modification needed.  Also which year car has the best electronic fans to replace the horse power robbing fan i have now...thx for the help

I think all those TB\'s should fit your car equally well, but I\'m not sure.  As for the fans, I used \'91 Stanza fans, and henge used Maxima Fans, \'88 I believe, and we both are pleased with them.

Here\'s a writeup on my fan install:
http://www.v6-s12.com/Projects.htm[/a]

Make sure the TB is from a auto Stanza because I think the 5spd is only 55mm.

aight man thx for the info, ok now does the TB bolt directally in, do i have to remove anything, and do i need to get any extra parts or plugs?

get about a foot of vaccuum line..(dont remember size, sorry...) and a t-connector for the vaccuum lines..a gasket for the TB, and some patience if yoyu have to swap over the springs form your VG throttle body to the KA24 TB...takes some time! (just cause its a pita)..if you dont get the springs (yes, there are two) right..you\'ll have a weak gas pedal, or weird ass accel...

Best fans. the fans off the older nissan maxima it has twin fan it swaped then into my 300zx and my s12. frees up alot of space to

Best fans. the fans off the older nissan maxima it has twin fan it swaped then into my 300zx and my s12. frees up alot of space to

henge
sure does free up some space! i used the fans out of a '88 Maxima



and here is a pic of the kind of space you get:

Anyone find or use a setup for 6 TB's for the individual runners?

why use a shitty stanza one?take one off a 240.