s13 swaybar

if i was to use the pintara/skyline castor rods, s13 control arms....
would i be able to use an s13 swaybar?
also do the s13 rack ends work with the standard rack, i am using an older model skyline/pintara rack for power steering.

kind regards
Liam

ive been told that the s13 sway bar is weaker than the s12, so it would be pointless to put in an s13 unless your point is to increase body roll?

the S13 ones are hollow whereas ours are solid

i dont need to know how good they are, just if they fit, saves me a bit of running around, becasue if an s13 bar fits, then an aftermarket from another car will fit, giving me the sump clearance that i need.

i dont recall asking the specification of an s13 bar only the fitment?
HAHAHA Damn right Indy, how dare you? :no: No more kind regards for you :rofl:

Oh so he changes his post and all of a sudden I look like an idiot, you lot are all so crafty.

PDM racing sway bars for 240sx are solid and yes they fit... with mods of course.

It's not a perfect fit with S13 arms but it's close.

thanks neb, the only one that can answer the question.
"Fazmo Oh so he changes his post and all of a sudden I look like an idiot, you lot are all so crafty. "
i didnt change my original post if you take the time to look, i asked "will it fit", not is it better

thanks

The S13 bar is a little wider.
I got this pic that shows the endlinks lean over a bit to go through the holes in the control arms.
http://img.photobucket.com/albums/v471/Nebuchernezzer/My%20Car/DSCN1632.jpg

Hey neb, if u ever lift ur car up, could u rake a pic of the whole under setup of ur sway mod? It would help us all out. I wanna do this after I put my engine in.